AccuTools DS-220R, Руководство пользователя

Страница: 10 / 20

DS-220R User’s Guide
8
Over Range Indication
If the weight applied to the weighing platform exceeds the maximum capacity of the
DS-220R (100 kg), a single “
1 ” will be shown on the left side of the display. To
prevent damage to the DS-220R, immediately remove the weight from the platform.
Hold Mode
A special feature of the DS-220R allows the emptying or replacing bins or
containers used for weighing without affecting the weight shown on the display.
This Hold Mode may be used as follows:
1. Allow load to settle until display is steady.
2. Press . The HOLD indicator will turn on and the current weight is now locked
on the display.
3. Remove, empty, or replace objects, bins, or containers on the platform.
4. Wait 5 seconds for the new load to stabilize.
5. Press . The HOLD indicator will turn off. Measurements will continue from
where they left off prior to initiating Hold Mode.
Programming
With the DS-220R, a programmable threshold weight will sound an alarm. The
alarm will sound when the displayed weight (either positive for increasing weight, or
negative for decreasing weight) equals the programmed weight. To program the
alarm, perform the following steps:
1. Set up the DS-220R with the desired units and resolution as described in the
Quick Start Setup section above.
2. If measuring decreasing weight, place the objects or container with the objects or
material that will be removed on the weighing platform.
3. Press to start the SET Mode, indicated by the SET annunciator on the LCD
display.