Accurate Technology DigiStop-4, Руководство по установке и эксплуатации

Страница: 11 / 20

Accurate Technology Digi-Stop Page 11 of 20
additional 1/64 of an inch measurement making the true, full resolution
measurement 2 13/64ths.
Some users find this resolution unnecessary and prefer the 16ths or 32nds
mode instead. For better resolution, switch to 64ths mode. For the best
resolution switch to a decimal mode
– inches or millimeters..
When the measurement is greater than 99 63/64 inches, a
+100
and/or
+200
will illuminate in the upper right portion of the display to indicate this amount
must be added to the displayed reading. For example; the LCD pictured above
right is indicating a measurement of 151 39/64 inches. If the measurement was
351 39/64 inches, the
+100
and
+200
will be illuminated on the display.
+,
DATUM
, and -
The + (plus),
DATUM
and
–
(minus) keys are used to change the currently
displayed position to a different value. The
DATUM
key forces the readout to a
user programmed value. Programming Parameter Pr1 (default is zero 0.00)
Momentarily depressing the + key increments the current reading by one unit
(fractions, decimal or mm depending on the current mode selected by the
UNITS
key) of measurement. Momentarily depressing the
–
key decrements
the current reading by one unit. Pressing and holding the + or
–
keys will cause
the displayed reading to change continuously. Holding down the key will cause
the amount of change to speed up. This allows for quick adjustments over a
range of large values.
NOTE: While the
DATUM
key can be used to simply “zero” the currently
displayed reading, it can also be programmed to force the readout to a preset
value. This can be zero, or any other displayable value.
See Section 3: Readout Programming, Programming Parameter Pr1.
Reverse the Measurement Readings
Reverse the readings means changing the direction of measurement produced
by movement. If the Digi-Fence
decrements (reduces or goes negative) when it
should be incrementing (increasing or going positive), the readout will need to
be re-programmed for your installation.
See Section 3: Readout Programming, Programming Parameter Pr2.