Accurate Technology DigiStop-10, Руководство по установке и эксплуатации

Страница: 17 / 20

Accurate Technology Digi-Stop Page 17 of 20
Pr11
– Readout Measurement Units
······································· [ 0 to 6]
This parameter controls the type of measuring units the Readout displays when
the
UNITS
key is pressed. The table below illustrates the possible combinations
of measuring units that will be displayed by changing this parameter.
Default Value = 0
Pr12
– Readout Auto-Off Time
············································· [0 to 240]
This parameter changes the amount of time before the display turns off to
conserve battery power. The value is the number of minutes of idle operation
(no movement or key presses) before the display turns off. When this
parameter is enabled (

0 ), pressing the
ON
/
OFF
key or movement of the
encoder or system will wake up the Readout.
A value of ‘
0
’ disables the Auto Off feature (the Readout is always on).
Default Value = 15 (minutes)
Pr13
– Linear
Compensation
································ [0.00001 to 9.99999]
This parameter invokes a linear multiplier correction in the Readout that is
applied to the actual measurement prior to any offsets. This adjusted
measurement is then displayed on the Readout. This is useful, for instance, if
you would like to display half, double, or other values that can be achieved by
multiplying the actual measurement by the value of the parameter setting.
Use care when enabling this function. It will force the readout to display a value
different from the actual measurement or position.
This Programming Parameter does not apply to all Digi Systems and products.
DO NOT change this value unless instructed to do so by a factory technician!
Default Value = 1.00000
Pr 11 Setting Displayable Units
0 All inch units and millimeters
1 Millimeters only
2 Decimal inches and millimeters
3 Decimal inches and centimeters
4 All inch units and centimeters
5 Centimeters only
6 Decimal inches only