Accurate Technology DigiStop-10, Руководство по установке и эксплуатации

Страница: 12 / 20

Manual Part # 800-1070-001 Rev 10-2016 Page 12 of 20
Readout Lock
To activate the Lock function Press and hold the
ON
/
OFF
key and then
momentarily press the
UNITS
key. The word
LOCK
will appear in the upper left
corner of the readout. When
LOCK
is displayed, the + ,
DATUM
and
–
keys
become inactive to prevent accidental changes of the (calibrated) current
displayed position. To de-activate the Lock function, press and hold the
ON
/
OFF
key and then momentarily press the
UNITS
key.
NOTE: The Lock function can also be enabled/disabled through programming.
This allows a more permanent Lock function since programming can be
disabled with a hardware jumper inside the readout thus preventing any front
panel programming changes.
See Section 3: Readout Programming, Programming Parameter Pr3.
Readout Resolution
The Digital readout can be configured to display measurements in any of three
different resolutions.
1. Low
– the resolution is
.1in or .1mm.
2. Normal
– the resolution is:
.01in or .01mm.
3. High
– the resolution is:
.001in or .01mm
The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64
See Section 3: Readout Programming, Programming Parameter Pr4.
Measurement Units
The measurement units displayed on the Readout are user configurable. The
table below provides a matrix for selecting the measurement units that may be
displayed when pressing the
UNITS
key.
See Section 3: Readout Programming, Programming Parameter Pr11
Programming Parameter Pr 11 Value Measurement Units Displayed
0
All inch units, and millimeters
1
Millimeters only
2
Decimal inches and millimeters
3
Decimal inches and centimeters
4
All inch units, and centimeters
5
Centimeters only
6
Decimal inches only