4
P
ANEL
The LCD Display shows the temperature in ºC or ºF, depending on the option.
•
If the unit has the battery-backup option, the display shows a BAT message to indicate that
there has been a power loss and it is running on the battery.
The STATUS tricolor LED shows the status of the unit.
Green = temperature in range
Red = temperature is out of range
Amber = program mode
The light blinks off briefly each second to show the unit is active.
The ALM TEST push-button interrupts line power, to allow testing of the battery and the alarm relay.
The bright red ALARM LED shows alarm conditions.
•
In alarm mode, it flashes every half-second.
•
In alarm mute mode, it gives a short blink every second.
The BEEPER shows alarm conditions and user activity.
•
In alarm mode, it gives a long beep.
•
In alarm mute mode, it gives a short chirp.
•
It gives an audible tick to indicate a button has been pressed.
The MUTE/PROGRAM button has three functions.
•
In Normal Run mode, if the unit is beeping, pressing the button will mute the beeper for a
preset time. Each time the button is pressed the mute time resets.
•
Holding the button down for two seconds takes the unit out of Normal Run mode and into
Programming mode. At the same time, it mutes the beeper.
•
When in Programming mode, pressing the button steps the unit through the various
programming parameters.
The HI/INCR button has a different function for each operating mode.
•
In Normal Run mode, pressing the button causes the high temperature set point to be
displayed.
•
In Programming mode, pressing the button increases the displayed parameter value.
The LO/DECR button has a different function for each operating mode.
•
In Normal Run mode, pressing the button causes the low temperature set point to be
displayed.
•
In Programming mode, pressing the button decreases the displayed parameter value.
