TOP COUNTER
The top counter allows material to be run across the
inspection ta-
ble
pile side down and still receive an accurate measurement. The
top counter,
consisting of two measuring wheels and a digital coun-
ter, is designed to be used in conjunction with a
pinch roller
provid-
ing a manner in which full rolls of carpet can be reverse rolled pile
side out and measured
at the same time
.
The top counter is attached directly to the hold down arm. Measure-
ments are made with
top counter
in the same manner as the stan-
dard counter except when measuring a roll balance, line the leading
edge of the material up with the center of the top counter wheels –
not the
measuring wheel
in the
inspection table
.
Note
:
The
top counter
uses a decimal type measurement and a conversion
table must be used to convert the measurement to feet and inches.
MANUAL WRAPPING DISPENSER
Stretch wrap will always be within arms reach with a manual wrapping dispenser. To wrap the cut length,
keep the roll-up cradle
roller directional switch
in the forward position and place the load cradle
roller
directional switch
in the off position. Place the wrapping material inside the flap of the material you are
wrapping. Stepping on the
foot cable control
will rotate the roll, letting you wrap the material while it is
still on the machine. Simply pull the dispenser assembly along as the roll wraps itself.
Photo 16A
Photo 16B
Wheeled Dispenser Base
Track
