Rolling up the material
Now that the counter is set to zero (0) advance the leading edge of the material just past the center of the
2nd. big roller on the roll up cradle, (see photo 8A)
(if using a paper core, place it on top of the material in
the cradle now).
Now close up roll-up arm (see photo 8B).
Warning: Keep hands clear of the roll-up arm.
Advance the material till the desired length.
NOTE:
After the material has made several revolutions open roll-up arm (see photo 8C)
(If roll-up arm is not opened early enough the material may pile up on the inspection table).
Keep pressure on the roll to ensure a tight roll (see photo 8D).
(You may also tighten the roll by continuing to rotate it after the cut).
Should the roll need to be adjusted in the cradle, open roll-up arms and adjust by hand.
Photo 8A
Photo 8A
Photo 8C
Photo 8D
