Accorroni AS COND, Руководство по установке

Страница: 13 / 56

13
UNION OF THE FAN SECTION WITH THE HEATING SECTION OF WARM AIR HEATERS
"AS COND 600 " and variants
The warm air heaters X 600 and variants are produced and delivered in 2 sections (fan and heating).
Proceed as follows:
- remove the packaging of the 2 sections;
- remove the pallet by lifting the ventilating section (A) by means of the 4 lifting eyebolts located on the
upper profile of the section itself;
- place the ventilating section (A) on a level floor;
- remove the 4 lifting eyebolts
- position the self-adhesive gasket (2) supplied along the side of the aluminum profile so that it adheres to the
aluminum profile of the heating section (B);
- place the heating section (B) on the ventilating section (A) using the 4 lifting eyebolts located in the upper profile of
the section itself;
- remove the 4 lifting eyebolts
- for mod. XO and XEO join the 2 sections horizontally;
- fix the 2 sections with the supplied screws through the brackets (1) located in the fan section (A);
- connect the tri-thermostat to the electrical panel with the supplied cable.
The warm air heater is supplied with screws, plates, brackets and self-adhesive gaskets for the versions XO e XEO .
ASSEMBLY OF THE BURNER PROTECTION CABIN FOR " AS COND EX 600" WARM AIR
HEATERS
Proceed as follows:
- place the edge (4) of the cabin on the upper profile of the warm air heater, on the burner side;
- drill the side profiles in correspondence with the brackets (3) of the cabin (holes Ø 5 mm);
- screw the brackets with the supplied screws
.
FIXING THE HEAD FOR DIRECT AIR DISTRIBUTION ON THE WARM AIR
HEATERS AS COND 300-425-500- 600 series
- Place the head for direct air distribution on the warm air heater
- Position the 4 brackets supplied (as shown in the photo).
- Screw the 16 self-drilling screws 6.3x16 supplied both on the profile of the
warm air heater and on the profile of the head.