AccessECU WRX 2002, Руководство пользователя, Страница: 49 / 70

ERROR, please try operation again message? ERROR, please try operation again message?
ERROR, please try operation again message? ERROR, please try operation again message? ERROR, please try operation again message?
This error can only occur when the AccessPORT is attempting to initialize the
ECU in preparation for a reflash. This message will occur when the AccessPOTR
is unable to communication with the ECU or is getting the incorrect responses.
Possible issues are:
A.
Poor connection to the vehicle
•
Verify DiagPORT connect is firmly attached to vehicle
B. The vehicle is not in Test Mode
•
Verify CEL light flashes and radiator fans cycle when key is in
'ON' position.
C. Key is not fully in the ON position
•
Verify Ignition Key is set to the full 'ON' position but vehicle is
not running.
D. User waited too long before pressing SELECT button
•
For 2002-2003 WRX models, Select (OK) button must be
pressed within 10 seconds from the time the Ignition Key is set
to the full 'ON' position.
E. User pressed SELECT button too early (2002-2003 WRX)
•
Try waiting 1-3 seconds longer after Ignition Key set to full 'ON'
position.
F. The incorrect type AP is being used on the incorrect vehicle
•
Verify part number location on Serial Number sticker (back of
AP) is the same type of vehicle
•
Verify Initialization screen displays same vehicle type
Other troubleshooting steps:
•
User can attempt clearing the ECU memory by disconnecting
the battery or ECU for a few minutes and trying again.
•
Contact technical support for further troubleshooting steps.
This ECU is already being used with an AccessPORT! HAL This ECU is already being used with an AccessPORT! HAL
This ECU is already being used with an AccessPORT! HAL This ECU is already being used with an AccessPORT! HAL
This ECU is already being used with an AccessPORT! HALTING OPERA TING OPERA
TING OPERA TING OPERA
TING OPERATION TION
TION TION
TION
message? message? message? message? message?
This error message can occur when a serial number already exists on the ECU
and the AP is attempting to marry itself to an ECU for the first time. Common if
the AP had been sent in for repair and it was not shipped back in the correct
"state" where it thinks it is new.
Contact technical support for further instructions. If AP has been serviced
recently, the AP will need to be returned to be placed in the correct state before
it may be used. This cannot be done remotely.
49