AccessECU WRX 2002, Руководство пользователя, Страница: 46 / 70

Tips and Troubleshooting
Please use this section to assist you in troubleshooting any problems that may
occcur when using the AccessPORT.
YYYYYou may also visit our online Knowledge Base to answer your technical ou may also visit our online Knowledge Base to answer your technical
ou may also visit our online Knowledge Base to answer your technical ou may also visit our online Knowledge Base to answer your technical
ou may also visit our online Knowledge Base to answer your technical
questions at: questions at: questions at: questions at: questions at:
http://www.accessecu.com/kb
AccessPORT T AccessPORT T AccessPORT T AccessPORT T AccessPORT Troubleshooting roubleshooting roubleshooting roubleshooting roubleshooting
AP won’t turn on when connected to car AP won’t turn on when connected to car AP won’t turn on when connected to car AP won’t turn on when connected to car AP won’t turn on when connected to car
Step 1:
Verify DiagPORT cable is firmly connected to the vehicle’s Diagnosis Port.
Step 2:
Verify DiagPORT cable is firmly connected to the AccessPORT
Step 3:
If that doesn’t work, remove the AccessPORT from the vehicle and use the
supplied 5V DC Power Adapter to power the unit.
If the AccessPORT turns on, have vehicle’s diagnosis port checked to verify it is
wired and functioning properly. The dealership should be able to perform this
test.
If the AccessPORT does not turn on, refer to “Service and Support” on page XX
for your authorized distributor contact information. They can assist with
additional troubleshooting steps.
Check Engine Light Flashing after Install Check Engine Light Flashing after Install
Check Engine Light Flashing after Install Check Engine Light Flashing after Install Check Engine Light Flashing after Install
If the Check Engine Light is flashing after using the AccessPORT, check to make
sure the Test Mode connector has been disconnected. Also verify you’ve
removed the Initialization Connector at the same time.
46