Page 6 of 13
Rev: Sept 22, 2008
COMPONENT IDENTIFICATION
1.
POWER BUTTON:
Used to turn the main/standby power on and off.
2.
REMOTE CONTROL SENSOR:
Used to pick up the transmitted commands from the RCU.
3/5. CHANNEL UP/DOWN:
Used to change the channels when the on-screen menus are not in
use.
4. STANDBY
INDICATOR:
Used to show the status of the converter box. The red indicator
will be on if the converter box is in standby mode. The green indicator will be on if the unit
is in viewing mode.
(The red indicator will also be on if the unit is in Analog Pass-Through
mode, Models 1020A, 1030, 1050, and 1080 only).
Rear panel
1. RF
IN:
Connect your roof top antenna here.
2.
RF OUT:
Connect your TV to the converter box with the supplied cable. This will output
channel 3/4 NTSC to your TV. Alternatively, use the “video output” to connect to your TV
for a better quality picture.
3. CH3/4
SWITCH:
Used to select NTSC Channel 3 (61.25MHz) or Channel 4 (67.25MHz).
4.
SMART ANTENNA CONNECTION:
Used to connect to a smart antenna rotator.
5. L/R
AUDIO:
Connect these stereo outputs to your TV, VCR or Hi-Fi.
6. VIDEO
OUTPUT:
If your TV has support for the RCA type jack, video input, it is
recommended that you use this connection over the “RF Output” connection.
7. SERVICE:
This RS-232 connector is used for software upgrades and servicing only.
8. MAIN
POWER:
Connect this to the main power (Model 1010); or external power supply
(Models 1020, 1020A, 1030, 1050, 1080).
CONNECTING YOUR CONVERTER BOX
The following diagrams show typical configurations only and may differ slightly to your existing
equipment. If you are unsure how to connect your converter box, consult the manufacturer’s user
manual supplied with your external equipment.
FOR TECHNICAL ASSISTANCE OR TO
PURCHASE SPARE PARTS, VISIT
WWW.ACCESSHD.TV
OR CALL 1-800-393-1246
Front panel
