Accent 1400 Hardware Manual for Dedicated Devices
Page 15
Removing the Wire Stand
If you do not want to use the stand, you can remove it from the back of the device. You can reattach it
at any time.
1.
Place the device face-down on a flat surface.
2.
Remove the screws from the holders at the end of each of the stand’s legs.
3.
Pull the holders free and put them in a safe place in case you need to use them later.
Loose holders could be a choking hazard.
4.
Spread the legs apart to pull them out of the holes in the back of device.
5.
Pull the stand free and put it in a safe place in case you need to use it later.
Important!
If you reattach the stand, be sure to secure the legs with the holders to prevent
someone from pulling it loose accidentally.
