Accelerated Concepts, Inc. ©2016
6300-LX User’s Guide
17 of 32
ACCELERATED.COM
Troubleshooting
Resetting Your Device
To reset the device to factory default settings, press the RESET/ERASE switch on the rear of the device. This will erase
all device specific settings and firmware updates and restore the device to its original firmware and settings.
Establishing Backup Connectivity via Ethernet Port
If the device cannot connect using a cellular connection, use the following steps to use the Ethernet WAN connection.
Restore the device to its factory default settings.
Connect the Ethernet port of the device to the site network equipment/router. This may be done either directly
with an Ethernet cable or via the POE injector cable (6). Refer to the section “Using the Passive POE Injector
Cable” above. Check for solid LINK and flashing ACTIVITY LEDs on the device WAN Ethernet port.
Ensure the router connected to the Ethernet port of the device is configured with an IP address of
192.168.210.254/24. The device will try to use this as its gateway IP address for backup connectivity.
Observe the
Status Indication LEDs & Signal Strength
sections to aid in diagnosis.
Note:
Backup Connectivity via Ethernet Port and WAN connectivity via Ethernet Port features cannot be used at the
same time. If you use the steps listed here to set the device’s Ethernet port as a backup connection for itself,
the 6300-LX will not be able to provide WAN connectivity to client device(s).
