Accelerated Concepts, Inc. © 2015
14
of
16
6200-FX Troubleshooting Guide v1.3
Real-Time Management
Below are details for all the commands that can be sent to a 6200-FX device, along with details as to
what each command does.
Remote Control
Check status - the 6200-FX will immediately send its current status
Check signal strength - the 6200-FX will send its signal strength and network info once every 10
seconds for the next 15 minutes
Perform Speed Test - the 6200-FX will perform a speed test and send the Upload/Download results
ARPing Attached Device - the 6200-FX will attempt to ARPing the client device attached to its
Ethernet port.
Send Wake-on-LAN to Attached Device - the 6200-FX will sent a wake-on-LAN packet to the client
device attached to its Ethernet port.
Check Configuration - the 6200-FX will immediately pull its configuration and reboot to apply any
new settings
Reboot - reboot the 6200-FX
SMS
Set Configuration - a popup window appears where a user can enter in a configuration
option or set of options to apply to the 6200-FX. Multiple config options must
be separated by a comma. For example, if a user wants to set the APN of a 6200-FX
to managedvpn, they would enter "modem_apn=managedvpn".
Configuration Reset - restore default configuration on the 6200-FX and reboot.
Firmware Reset - restore to backup firmware image on the 6200-FX, and reboot.
Factory Reset - restore default configuration on the 6200-FX, restore to backup firmware image, and
reboot.
Remote Control - tell the 6200-FX to bring up its remote control tunnel (useful if on low data plan, so
the remote control tunnel is not always up using data).
Reboot - reboot the 6200-FX
