background image

ã

 Copyright 2003  All Rights Reserved

In House/Instructions/Manuals/AS635/805 Owner’s Manual.cdr

Page 8

AS635/805

OWNER’S MANUAL

SECURITY SYSTEM 

WITH STARTER

The 

Pulsed

 operation setting allows an output to activate as long as the button is held.

The 

Timed

 operation setting allows an output to activate when the transmitter button is pressed, and remain

activated for 10 seconds or until the transmitter button is pressed again.
The 

Latched

 operation setting allows an output to activate when the transmitter button is pressed, and remain

activated until the transmitter button is pressed again.

If auxiliary 1 is installed to activate the vehicle’s trunk release, the system can be programmed to automatically disarm
the alarm when the trunk is opened using the transmitter.  In this manner, the trunk can be accessed without first
disarming the alarm.

When parking the vehicle in areas susceptible to unwanted disturbance from animals or strong weather conditions that
could cause the sensors to trigger, the sensor inputs can be temporarily bypassed using the remote transmitter,
preventing possible false alarms.

To disable the sensor inputs.
    1.  Arm the system normally.
    2.  Within 5 seconds of arming the system, press the arm button again.
         •  The siren will chirp 5 times and the parking lights will flash 5 times to indicate the sensors are disabled. 
         •  The sensors will remain disabled until the next arming cycle.

DISARM WITH AUXILIARY FUNCTION

REMOTE SENSOR DISABLE

E L E C T R O N I C S        I N C .

Содержание AS635/805

Страница 1: ...hicle s trunk release the system can be programmed to automatically disarm the alarm when the trunk is opened using the transmitter In this manner the trunk can be accessed without first disarming the alarm When parking the vehicle in areas susceptible to unwanted disturbance from animals or strong weather conditions that could cause the sensors to trigger the sensor inputs can be temporarily bypa...

Страница 2: ...stored transmitter codes be sure to program all 4 transmitter memory locations To program the transmitter s 1 Turn on the ignition key On Off On Off and back On Key On 3 times The siren will chirp 3 times 2 Press and hold the Override switch for 5 seconds The siren will chirp 5 times The LED will illuminate 3 Press Button 1 on the first transmitter The siren will chirp once 4 Press Button 1 on the...

Страница 3: ...show only one of three bars in the battery icon or the display and sounds may suddenly stop and start as the battery voltage drops below minimum In order to change the battery first slide the battery door locking pin to the side Carefully slide the battery cover downward until it is free While replacing the battery make sure that the positive and negative terminals are positioned correctly then ca...

Страница 4: ...ound only when the system is triggered The system is also capable of temporary silent operation if desired Pressing the Shift button before Arming or Disarming the system will bypass the chirp confirmations and allow one time silent operation Note The open zone warning chirps will not be bypassed when the system is Armed or Disarmed silently SILENT ARMING DISARMING When programmed for the optional...

Отзывы: