Accel Crestline Altra Series, Руководство по установке

Страница: 21 / 41

21
7
8
9
INSTALLATION
Install the oscillation drive assembly on the oscillator journal. Make
sure the bearing, installed in step 4, is seated in the housing before
securing the drive assembly to the oscillator using the new hard-
ware (subject arrow).
Replace the pin in the block with the new one provided. Install the
block and arm assembly (subject arrow) by first inserting the arm
on the pin in the worm gear. The set screw holding the pin in the
block goes toward the press frame. Rotate the assembly until the
holes in the block line up with the holes in the press frame. Loosely
install the bolts securing the block to the press frame. When
everything is properly aligned, the vibrator will be easy to turn by
hand and you can tighten the bolts.
Install the new water form roller into the original form housing.
At the OPS, tap the lower water form lever stop pin (subject arrow)
toward the outside of the press about 1/4" to allow for dampener
frame clearance. Do not over-tap or the press cover will not close.