Accel AV304, Руководство пользователя

Страница: 56 / 74

50
5.11 Camera- PTZ
Set the camera audio and P/T/Z environment.
5.11.1. Protocol
Set the protocol to control the P/T/Z controller connected to P/T/Z port on the back panel. P/T/Z controller is also
called receiver or RX if it becomes separated from camera. Default is NONE, which indicates that the P/T/Z
controller protocol is not set. Protocol currently supported is shown below.
1 Ernitec 2400 baud rate no parity 8bit 1 stop bit
2 Kalatel 9600 baud rate no parity 8bit 1 stop bit
3 Panasonic 19200 baud rate no parity 8bit 1 stop bit
4 Pelco D 2400 baud rate no parity 8bit 1 stop bit
5 Pelco P 4800 baud rate no parity 8bit 1 stop bit
6 Scc-641 9600 baud rate no parity 8bit 1 stop bit
7 Sensormatic 2400 baud rate no parity 8bit 1 stop bit
8 Smart Scan 9600 baud rate even parity 8bit 1 stop bit
9 VC_C4 9600 baud rate no parity 8bit 1 stop bit
10 Vicon 4800 baud rate no parity 8bit 1 stop bit
Set the controller address correctly for each channel after setting the protocol.
5.11.2. Address
Set the P/T/Z driver address of the connected camera.
Check the below items for proper P/T/Z operation.
1.
Check if the protocol of all P/T/Z controllers connected to the system is in accordance.
2. Check if the communication setting including baud rate of all P/T/Z controllers is in accordance with the assigned
value for that P/T/Z protocol.
3. Check if the address of all controllers is in accordance with the controller address assigned in the setting
menu for that channel.
4. Check if the power of the P/T/Z controller is turned on.
5. Check if wiring to P/T/Z controllers is correct.