Acard ARS-2051PC, Руководство пользователя

Страница: 45 / 55

43
5.2.13.5 Verify HDD
Now press ESC to return to Function#13, and then select part 5 Verify HDD as the following figure
shows. Verify HDD is to verify if the hard disk or any of its partitions can work well.
13-05. Adv Setup
Verify HDD
Press ENT to enter the next figure. Use
▲ ▼
to confirm Disk or Parti.
Press ENT to verify. After verification LCD will show the results as follows.
Verify HDD
OK
Verify Disk or
Paration? Disk
5.2.13.6 Burn-in
Now press ESC and
▼
to enter the following figure. Burn-in is to simulate Erease&Copy, Testing
and Comparing progress many times. The time can be from 1 to 1000. After each cycle of
simulation, the medias on the DVD writers will eject automatically and recede for the next bout of
simulation.
12-06. Adv Setup
Burn-in
Press ENT to enter the next figure. Test is simply a simulation. And there are Compare and
Erase&Copy options can be selected.
Burn-in
Test
Press ENT and use
▲ ▼
to select the time of simulation such as 1, 2, 3...1000 or Run
Continuous. The figure below shows Run Continuous.
Sel burn-in num:
Run Continuous
Press ENT and use
▲ ▼
to select the time of trayout such as 10sec,30sec,60sec,90sec ...150sec
or 180sec. The figure below shows 60sec.
Sel Trayout Time
60 sec
Attention
“Erase & Copy” is doing erase & write repeatedly, only rewritable
media is supported.
“Compare” is used to compare the source & target if they identical.
Audio CD is not supported due to no ECC.
“Test” is doing copy simulation, DVD+R is not supported.
ARS-2051PC/2074C/2078C Manual