AC Schnitzer AC S II, Инструкция по монтажу

Страница: 22 / 44

22
F i t t i n g I n s t r u c t i o n s
AC Schnitzer Hand Lever AC S II
2. Fitting
S 1000 RR up to mj. 2014
- Serial bushing has to be used
S 1000 RR from of mj. 2015
- Lightly grease plain bush supplied, and push into
the adapter bore. (Fig. 10)
- On the back of the standard lever, dismantle
microswitch pusher and remove pusher. Place
standard pusher in the same position on the AC
Schnitzer lever and tighten using the fixing screw
supplied. (Fig. 11)
Insert lever in the standard fitting. Screw in fixing
bolt. From below, fit washer and (new) M6 nut and
secure (6Nm), counter-holding the fixing bolt.
- Connect clutch cable and pretension knurled
knob. Set clutch play according to BMW
specification with cold engine, ensuring that the
clutch play is present in all handlebar positions.
- Check for correct function of microswitch. (Both)
microswitches must audibly switch.
(Fig. 12)
- With the clutch lever pulled, the headlamp
flasher switch must not operate. If necessary,
loosen the fitting and twist accordingly.
- Then carry out a test ride and check the function
of the electrical system (brake light etc.).
- Ensure correct fitting!
- The general operating licence must be given to
the customer.
Fitting Instructions Hand Lever Type AC S 2 / Issue: 01 / 2017 RVo_REV_1
AC Schnitzer - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -300 Fax -135 / www.ac-schnitzer.de