AC Schnitzer AC S II, Инструкция по монтажу

Страница: 19 / 44

19
F i t t i n g I n s t r u c t i o n s
AC Schnitzer Hand Lever AC S II
2. Fitting
- General Notes -
- Before starting work, park the vehicle safely
and secure against falling or rolling away. (Fig. 1)
- After completing the work, carry out a test ride
and check that the hand levers and electrical
system (clutch switch / brake light switch / GRA
switch and lighting system) function properly.
- A general operating licence is supplied with the
AC Schnitzer hand lever type ACS2. This must be
given to the customer with the information that
these documents must be carried on every ride !
- The AC Schnitzer hand levers have 6 settings.
The current position can be seen from the line
marking. (Fig. 2) To adjust, press the hand lever
slightly forward (in direction of travel), and turn the
adjustment lever clockwise/counter-clockwise as
required. AC Schnitzer recommends that
adjustments are only performed when parked. In
all cases, ensure there is sufficient remaining
travel on operation. AC Schnitzer bears no
liability for damage resulting from incorrect
installation and lack of remaining travel!
- Before mounting on the vehicle, install the long
or short extension (1 long & 1 short supplied per
lever) using the fixing bolts supplied. For this, from
the outside insert the desired extension flush into
the guide of the lever concerned, and secure with
6 bolts per lever.
- Warning: Do not overtighten bolts!
(Fig. 3)
Fitting Instructions Hand Lever Type AC S 2 / Issue: 01 / 2017 RVo_REV_1
AC Schnitzer - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -300 Fax -135 / www.ac-schnitzer.de