Abus Smartvest, Руководство пользователя

Страница: 56 / 63

56
English
Security settings
In the security settings, you can change the security code and
password for the Smartvest settings. It is strongly recommended
that you change both passwords when performing the initial
setup.
Device security code
Enter the old security code followed by the new one. Confirm this
again, then tap "Save".
Note
The security code is automatically changed in the end
device central settings where the change was carried
out.
With other end devices, you must change the device
security code in the general settings (see point 2.4,
General settings) before you log in next time.
Password for settings
Enter the old password for the settings and then the new
password for the settings. Confirm this again, then tap "Save".
Note
If you have forgotten your security code or your
password for the settings, you can reset these to the
standard value "123456".
To do this, press the reset button on the Smartvest
using a paper clip for ten seconds (while operating);
this will restore the Smartvest's factory settings. This
safeguards the pairing with the components and
ensures the most important settings are retained.
Status configuration
Select the status you would like to configure. This is how you
specify how your Smartvest will react in the relevant status.
Activated
Select the actuators and sensors you would like to trigger and/or
detect in "Active" status.
Exit delay
Activate the exit delay so you have enough time to leave the
house after arming the Smartvest. The exit delay applies for both
"Active" and "Part set".
Note
In "Active" status, all actuators and sensors are
activated as standard.