ABTronic SPORT-ELEC MULTISPORTPRO, Руководство пользователя

Страница: 8 / 54

EN
CT
CS
JA
8
- USER MANUAL
4
CHOOSE THE WARM-UP PHASE AND / OPTION
Only for categories 02 to 07.
f f
The screen proposes a warming-up phase before starting the active phase of the program.
The WARM-UP PHASE pictogram blinks in the top right corner.
To select it, press
, otherwise press the key and validate (it disappears from the screen).
f f
Then the
ALT / SIM
pictogram blinks.
To select
ALT
, press the key, then validate
To select
SIM
, press the key, then validate .
If you have selected the warm-up phase,
SIM
is displayed when starting the program, as the warm-up phase is only in the
simultaneous mode.
The pictogram for the program category chosen is lit, the muscle zone(s) chosen blink alternately.
The screen is displayed:
- the battery level,
- the phase duration (countdown in minutes),
- the timer pictogram,
- the
ALT
or
SIM
option and warm-up phase if you have selected them.
5
LAUNCHING THE START - ADJUSTING INTENSITY
You must press the buttons matching the cables to the pads (or to the accessories) for starting a program.
For increasing the intensity level and changing the strength of the stimulation, press 11 times to move to the next level.
The intensity level(s) is/are displayed at the bottom of the screen. Do not start a program if the battery level is low.
The intensity ranges vary during the session according to the program.
Warning! The unit is equipped with a security system that locks the launch of a program if the electrode pads are not
placed correctly on the skin.
6
PROGRAM PERFORMANCE
f f
Use of the (Clear) key
During the program, you can press the key to cancel the ongoing phase.
The next phase starts unless you have reached the end of the program.
In this case, this key allows returning to selecting the 1
st muscle zone (as at normal end of program).
f f
Disconnecting the electrodes during the program
If an electrode is disconnected, the channel concerned is reset to and blinks for 30 sec, before returning to a fixed .
During these 30 sec, the electrode(s) can be reconnected, and power restored to the level required.
7
END OF PROGRAM - STOPPING
At the end of the session, the screen proposes to start a new session by blinking the front muscles to select the 1 st muscle zone.
Restart the starting procedure if you wish to continue on another muscle zone.
Otherwise, press the key to stop.
The unit switches to standby after 5 minutes idle.
III. USING THE UNIT
A. USING THE DEVICE WITH THE BELT (Optional Accesories)
The belt has 2 pairs of snap fasteners onto which 2 wireless electrodes specially designed by SPORT-ELEC® are clipped.
To obtain new electrodes, contact your usual retailer or order them from our website www.sport-elec.com.
Warning!
Never use the belt without attaching the 2 electrodes provided.
Only use electrodes supplied by SPORT-ELEC®.
PRESENTATION OF THE BELT :
1 = Snap fasteners
2 = Wire storage flap
(with a lopp fixing device)
3 = Scratch strip
1
2
3
1