ABSTRACT ClubColour, Инструкция по эксплуатации

Страница: 5 / 20

Page 5
6. Microphone. The unit can sense the beat of the music through this built-in
microphone. The microphone is bass-filtered and will only pick up low-pitched
sounds.
7. Mains power (not shown in picture). Power is supplied to the unit through an
IEC connector on the back face of the unit. There is a power supply fuse built
into this connector. If this fuse fails you should take the unit to an Abstract
dealer for service.
Futurescan 1, Gladiator Revolution and ColourFlood have captive power leads
instead of the IEC connector.
8. Lamp alignment (not shown in picture). ClubScan and ClubRevolution only.
On the bottom of the unit (the opposite end from the mirror) there are 3
screws marked “Lamp align”. These allow you to adjust the position of the lamp
within the reflector to optimise the evenness of the light beam.
The alignment is set at the factory and you should not need to change it until
you renew the lamp.
9. Focus (not shown in picture). You can focus the light beam for sharp gobo
projection by turning the lens. If you turn the lens anticlockwise several turns,
the lens will come out of the unit allowing it to be cleaned.
On the Twister 4, MoonScan, MoonRay and Galactic Star, there is a slider knob on
the top of the case. Turn the knob anticlockwise to loosen it, focus by sliding
backwards and forwards, then turn the knob clockwise to lock the focus
position.
10. High/Low switch (not shown). Not fitted on all units. This switch is a “lamp
saver” which controls the power to the lamp. When set in “Low” position, the
lamp is run at a lower power which slightly reduces the brightness, but greatly
increases the lamp life. “High” position gives full brightness and normal lamp life.
11. Remote control socket (Futurescan 1, Gladiator Revolution and ColourFlood).
The “remote control” (3 buttons) can be connected to this socket using a stereo
jack cable. Do not connect any other equipment to this socket or damage may
result.
Note: when power is not connected to the unit, the DMX input and
output connectors are bridged through by a relay to maintain the
DMX circuit.