_____________________________________________________________________________________________________________________
Absolute Measurement Ltd. (T/A CMC Controls)
t: (0) 1732 763278
| e:
| w: absolutemeasurement.co.uk
Unit 19
| Silver Birches Business Park | Aston Road | Bromsgrove | B60 3EU
5
Transducer Instruction Manual
Range:
Ultra
Type:
CLT
Revision:
V1.0
2.8
Sensing Roller Installation
The transducer has a choice of adaptors with bores of 17, 20, 25, 30 and 35mm diameter, to accept a
shaft to which a tension sensing roller or guide pulley can be mounted as shown below. Two set screws
at 90
degrees are used to hold the shaft in place. The tension sensing roller or guide pulley should be
dynamically balanced when the roller speed exceeds 300 RPM as excessive vibration can damage the
transducer. Any out of balance force should not exceed 10% of the maximum working force (
MWF
) of the
transducer.
The recommended maximum roller length is 450mm to avoid an excessive bending moment being
applied to the transducer and roller deflection.
