Absco Industries
Assembly Instruction Manual
ABSCO POOL PUMP COVER
MODEL: PPCK
1.52mW x 1.52mD x 1.49mH
Model: PPCK
1.0
8
27/4/23
LID PANEL ASSEMBLY
1.
Overlap specified sheets as
shown. Make sure ends are flush.
Where possible, keep sheets in
the same orientation from the
box.
2.
Fasten with self tapping
screws through prepunched
sheet-to-sheet holes on overlap.
If you can’t see bottom hole twist
the sheet left or right.
Make a new hole with supplied
drill bit if bottom hole is too far
up or down the sheet or not
found.
3.
Attach the top and bottom
channels using the SNAP-TiTE
method.
Make sure you have the short
side of the channel to the
outside of the sheeting
PPA
PPA
81E
88C
81E
SN
APT T
E
i
SN
APT T
E
i
88C
4.
Attach the 88C lips to the
ends, place the face with the
holes on top of the sheet.
Fasten each using five FAST001
self tapping screws into the
prepunched holes.
FAST001
