Absco Industries
Assembly Instruction Manual
LARGE GABLE SHED
N3/C1 FRAME KIT
FOR WORKSHOP & UTILITY MODELS
Model: CYCWKUTK
02/03/21
1.3
19
BRACING FOR NON-GABLE WALLS - DOOR STUDS
Two C1704 are to be used as follows.
Take the framing for the door stud and
partially box them together,
do not tek
screw yet
.
1. Place the unscrewed box section against
the wall, in the orientation pictured, and slide
the two pieces apart until they make contact
with the floor and the roof panel.
2. Once the correct lengths have been
determined proceed to fix them with tek
screws at 296mm spacings as described in
BOXING FRAME SECTIONS.
3. Fix wall bracing to this stud with BKT17 as
previously shown in “BRACING FOR NON-
GABLE WALLS - PORTAL FRAME”
4. Fix roof panel to the top of the stud using
BKT 17 as shown below.
In instances where a portal frame is not positioned on both sides of the door opening, as per the
framing layout, a door stud is required.
C1704
BKT17 fixed to roof
sheet with 6 hex hd tek
screws with neoprene
washers from outside.
HEX HD
TEK SCREW W/ NEO
WASHER 10-16x16mm
