Absco Industries
Assembly Instruction Manual
ABSCO COMPACT GARAGE
MODEL: CG56552N2
5.64m W x 5.49m D x 2.64m H
Model: CG56552N2
16/10/19
4
5. Missing parts
To prevent damage in transit, some items are packed inside others. eg. some flashings may be
inside channel sections, other items may be packed inside gutters, some roof sheets packed on top,
some on the bottom etc. be very thorough when checking and locating all components.
6. Anchor sets not supplied (Hold down brackets are included)
Anchor sets are not supplied with this garage, but can be obtained from most hardware out-
lets. Anchors required for this garage are as follows;
11 Chemsets M10130 (10mm x 130mm Long)
2 M10 X 75 Dynabolts for P’ Door if applicable.
Note:
M10 x 125 long dynabolts can be substituted for chemsets
Frame Section Identification Guide
There are several types of frame section, each featuring a different combination of notches and/or
holes. Frame sections are coded with a letter representing the type of frame section, followed by the
length of the frame section in millimeters.
EG: C2960 = Straight cut both ends with overall length of 2960mm
C-TYPE - Straight cut at both ends
M-TYPE - 45mm lip notch at both ends
J-TYPE - Straight cut at one end: 20mm tab notch with
holes at other end
K-TYPE - 20mm tab notch with holes at both ends
L-TYPE - Straight cut at one end: 45mm lip notch at other
end.
N-TYPE - Straight cut at one end: 45mm lip notch/20mm
tab notch with holes at other end
P-TYPE - 45mm lip notch/20mm tab notch with holes at
both ends.
R-TYPE - 45mm lip notch/20mm tab notch with holes at
one end: 90mm lip notch at other end.
S-TYPE - Variable notching and/or holes nominated in parts checklist
