Absco Industries
Assembly Instruction Manual
Model: CYC15
02/03/2021
1.0
14
N3/C1 FRAME KIT
FOR 1.5m WIDE TO
1.5m DEEP MODELS
BRACING FOR SIDE WALLS
Construction for the side wall, on the door side, is different due to a door stud.
1. Take the two frame pieces for the side wall, and partially box them together,
do not tek screw yet
.
2. Place one end of the piece 120mm from the outside of the front wall as shown below.
3. Slide apart pieces apart until they make contact with it and the brace on the back wall. This is shown
below.
*For 15141RK this C1220 should be trimmed to 1190mm to help the door stud fit the wall brace.
C1220
C0660
One end of the wall brace dimensioned from the
outside of the front wall.
The other end of the brace butting up against
the back wall brace.
Side wall
C1220
120mm
C1220*
Now the horizontal wall framing is at the correct length proceed to fix them together and then use tek
screws to fix it to the side wall from the outside of the shed at 148mm spacings.
Use corner brackets (BKT10) to secure the rear,
side and front wall braces together. Position as
shown and fix using four tek screws. Pre-drilling
the bracket with a 3mm drill bit will make this
easier.
