E-38
ElektroPhysik
12.1 Recording a measuring series and
statistics calculation
On switch-on, the instrument is ready for operation. All
readings will be stored automatically. Before starting
measurement, check if it is necessary to calibrate for
your application and/or if the statistics must be deleted
(see section 12.5). If you recalibrate the instrument, the
old calibration settings will be deleted.
Note:
A measuring series can be recalled and continued after
off/on-switching.
12.2 Recalling and print-out of statistics
Press STATS-key as required to display the statistical
values subsequently in a row. If the printer is connected,
the readings will be printed out (printer ON). The
statistical values can be displayed or printed out as often
as required and at any time after measurement.
12.3 Print-out of readings and statistics
Press GalvanoTest PRINT-key. If the printer is
connected, the following values will be printed out:
- date and time
- all readings
- all statistical values
While printing, the alphanumerial display shows
„Printing...“. Press CLEAR-key for print stop if required.
If there is no printer connected or if the printer is switched
off, the data can also be transferred via the RS 232 C
interface (see section 19).
12.4 Deleting a previous reading
Deletion is only possible directly after the last
measurement , i.e. before taking the next one.
-
Press CLEAR-key.
-
An audible signal confirms deletion. If the printer
is connected, the following message will be printed
out: *Cancel*.