Abov MC96F6332SD, Руководство пользователя

Страница: 176 / 283

176
MC96F6432S ABOV Semiconductor Co., Ltd.
11.11 12-bit A/D Converter
11.11.1 Overview
The analog-to-digital converter (A/D) allows conversion of an analog input signal to corresponding 12-bit digital value.
The A/D module has eight analog inputs.The output of the multiplexeris the input into the converter which generates
the result through successive approximation. The A/D module has four registers which are the A/D converter control
highregister (ADCCRH), A/D converter control lowregister (ADCCRL),A/D converter datahigh register (ADCDRH), and
A/D converter datalow register (ADCDRL). The channels to be converted are selected by setting ADSEL[3:0]. To
execute A/D conversion, TRIG[2:0] bits should be set to
‘xxx’.The register ADCDRH and ADCDRL contains the results
of the A/D conversion. When the conversion is completed, the result is loaded into the ADCDRH and ADCDRL, the
A/D conversion status bit AFLAG is set to ‘1’, and the A/D interrupt is set. During A/D conversion, AFLAG bit is read as
‘0’.
11.11.2 Conversion Timing
The A/D conversion process requires 4 steps (4 clock edges) to convert each bit and 10 clocks to set up A/D
conversion. Therefore, total of 58 clocks are required to complete a 12-bit conversion: When fxx/8 is selected for
conversion clock with a 12MHz fxx clock frequency, one clock cycle is 0.66
μs. Each bit conversion requires 4 clocks,
the conversion rate is calculated as follows:
4 clocks/bit × 12 bits + set-up time = 58 clocks,
58 clock × 0.66us = 38.28us at 1.5MHz (12MHz/8)
NOTE)
1. The A/D converter needs at least 20us for conversion time. So you must set the conversion time more
than 20us.