2. Fix elbow (D) or inlet pipes (F) securely to the wall using appropriate fixings (G). Note these fixings should be
secure enough to support the attached product weight (A) safely during use.
Before installing this new connection,
it
is essential that you thoroughly flush through the supply
pipes
in order to remove any remaining solder, swarf or impurities from your system. Failure to carry out
this simple procedure could cause problems or damage to the workings of any attached product and
invalidate the warranty.
3. Make good the finished surface (E) using tiles or similar, now prepare hole ‘C’ in the tiles. Ensure back plate (B)
will cover the finished hole diameter ‘C’.
4. Insert foam seal (C) inside the back of back plate (B) as shown.
5. Once inserted slide back plate (B) over spout (A) as shown ensuring pre-inserted O-ring inside back plate (B) is
in place.
6. Screw the spout (A) into the elbow (D) using PTFE tape or sealing compound to ensure a water tight connection.
Test the water tightness of all inlet pipes and connections before progressing with the installation.
7. Watchfully Seal around the finished wall surface (E) and back plate (B) if applicable to prevent water ingress into
the wall. Note take care not to apply sealant to sections of thread on the spout (A) that are required for fixing
later.
Installation – Mixer Body
Key
Description
Qty.
Key
Description
Qty.
H
Back body
1
N
Dust cap
1
I
Plastic protection cover
1
O
Grub screw (2.5mm)
1
J
½”M x ½”M Connector (Basin)
½”M x ¾”M Connector (Bath)
0
P
Decorative cover
1
K
Foam seal
1
Q
Valve locking nut
1
L
Back plate
1
R
Single lever valve
1
M
Handle
1
S
Cache TT aerator
1
M
in
4
5
-
M
a
x
7
5
1/2” F
1
/2
”
F
1
/2
”
F
3
9
4
.5
1
1
0
