User manual Version 1.0
EW5302 Wireless Serial Server
Copyright © 2007 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 4 -
3. Software Setup
Now the EW5302 hardware is installed and the power is on, network IP configuration will be set in this
section.
3.1. Default Settings
The EW5302 has two IP addresses one for Ethernet interface and another one for wireless network
interface. These default settings are shown from under information
Default IP addresses
Device IP
Subnet mask
Gateway IP
10.0.0.50.100 255.255.0.0 10.0.0.254
The other default settings of EW5302 are shown in the following table
Property
Default Value
Wireless Client Adaptor IP
IP Address
10.0.50.100
Gateway
10.0.0.254
Subnet Mask
255.255.0.0
Security
User Name
Admin
Password
Null (Leave it blank)
Serial
COM
9600/None/ 8/1,No flow control, packet delimiter disabled
Link Mode
TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled
SNMP
SysName of SNMP
Name
SysLocation of SNMP Location
SysContact of SNMP Contact
Table 1.
Factory default settings of the EW5302
NOTE: Press push Reset button for 5 seconds and then release to restart EW5302 with the factory
default settings.
Warning: Please avoid setting LAN and WLAN IP addresses in the same subnet. This may create
unexpected networking problems.
