preparatIons, InstallatIon and takIng Into operatIon
13
9. The wallbox includes three custom
sealing membranes for the openings
in the lower part of the wallbox: Insert
these and cut a slit into the large seal-
ing membrane: Now insert the supply
cable through this opening.
10. Hang the wallbox onto the mounting
plate by inserting the screw in the
centre of the upper part at the rear
into the respective opening in the
mounting plate: this already protects
the wallbox from falling.
11. Now fix the wallbox to the mounting
plate using the screwdriver (TX25 bit)
and the four 6 x 25 screws included.
The wallbox is now securely fastened
to the mounting plate.
12. If using a power supply with flexible
wires, ensure that the stripped ends
are fitted with wire end ferrules. Loos-
en the lower screws in the terminal
blocks, insert the wires into their re-
spective terminals and tighten with
a torque of 2.5 to 3 Nm. The wiring
sequence is shown in the following
diagram and table.