ABK i-Cooking, Инструкция по эксплуатации

Страница: 21 / 24

EN 18 Installation
5.2 Installation
Making the appliance tension free
If the appliance must be made electrical
tension free, do as follows [depending on
the situation]:
1. Fuse
Unscrew the fuse and remove it from the
container.
2. Fuse machine
Press the [red] test button untill the middle
[black] button pops out.
3. Automatic fuse machine
Automatic switch , at least type B or C.
Switch the tumbler switch from 1 [on] to
0[off].
4. Earth leakage circuit breaker
Turn the main switch from 1 [on] to 0 [off]
or press the test button.
Atttention! Make sure that the
e l e c t r i c a l t e n s i o n c a n n o t
accidentallybe switched on again.
Recycling
The packaging of this appliance can be
fully recycled [cardboard] Ensure a proper
disposal of these.
If you must dispose the appliance itself,
please supply it to a specialized recycling
company, whic takes care of a proper
disposal and recycling of the used
materials of this appliance. Ask your local
authority where you can best hand over
this appliance.
EN 21 Installation
C. Release all switches and now press the
5.3 Configuration
on/off switch during several seconds,
unless blinking ”E“ codes appear.
Before the first use, the controls of the
D. Wait until the “E“ codes stop blinking.
appliance must be configurated. In this
After a few seconds the ”E“ codes will
procedure, the individual cooking zones
change into ”C“ .
are assigned to the positions on the
Attention! To configurate a 3-zones set the
control panel. Execute the following steps.
procedure starts from the top right side
instead of the below right side.
1 Remove pans from the cooking zones.
New configuration
2 Switch-off the electrical tension with the
fuse or main switch in your meter
cupboard.
.
3 Wait at least 2 minutes before you
E. Select the cooking zone position by
switch on the electrical tension again.
pressing the corresponding code ”C“ in
4. Start the configuration within 2 minutes
the display. Now place the pan onto the
after the tension is switched on again.
zone and wait untill the code ”C“ changes
Take a pan with a diameter of 16cm, do not
into code ”-“. The zone is now assigned.
use different pans within the configuration
F. Repeat the procedure of E to assign the
process.
remaining cooking zones. After all zones
have been allocated, the codes “-“ in the
Removing an existing configuration
display dissapear.
A. Press the symbol ”p“ and keep it
The application is now ready for use!
pressed. On the control panel the indicator
lights of the zones now light up.
Code E4
B. Keep the “p“ pressed and use your other
Reconfigure the zones and control again,
hand to quickly press each zone display,
start with removing the old configuration.
counterclockwise starting from the right
If this does not help, please contact your
side below. Do this total process within 2-
supplier.
3 seconds. You will here a confirmative
beep when you press each display. In case
of a succesful proces, in each zone a
minus sign appears. If you hear a double
beep, you must repeat the procedure from
step A.
codes
Take a pan with a diameter of 16cm, do not
use different pans within the configuration
process