Abit SI7, Руководство пользователя

Страница: 24 / 96

2-4 Chapter 2
The diagram below shows the possible combination of RDRAM installation.
NOTE:
No hardware or BIOS setup required after adding or removing memory modules.
ATTENTION: Static electricity can damage the electronic components of the computer or optional
boards. Before starting these procedures, ensure that you are discharged of static electricity by touching a
grounded metal object briefly.
Power off the computer and unplug the AC power cord before installing or removing memory modules.
1. Locate the RIMM slot on the board.
2. Hold two edges of the RIMM module
carefully, keep away of touching its
connectors.
3. Align the notch key on the module with the
rib on the slot.
4. Firmly press the module into the slots until
the ejector tabs at both sides of the slot
automatically snaps into the mounting notch.
Do not force the RIMM module in with extra force as the RIMM module only fit in one direction.
5. To remove the RIMM modules, push the two ejector tabs on the slot outward simultaneously, and
then pull out the RIMM module.
WARNING:
RIMM modules become extremely hot during operation. Don’t touch the heat spreader
before it cools down.
SI7 Series