Hardware Setup
2-3
2-3. Install System Memory
This motherboard provides two 232-pin 32-bit RIMM (Rambus Inline Memory Modules) slots for
PC1200/PC1066/PC800 Direct RDRAM.
ATTENTION:
The PC1066 RIMM modules require CPU of 533MHz FSB only. Do not use PC1066
modules with CPU of 400MHz FSB.
Table 2-1. Valid Memory Configurations
Bank
Memory Module
Total Memory
Bank 0, 1 (RIMM1)
128, 256, 512MB, 1GB
128MB ~ 1GB
Bank 2, 3 (RIMM2)
128, 256, 512MB, 1GB
128MB ~ 1GB
Total System Memory
128MB ~ 2GB
NOTE:
RIMM modules are limited to a total combination of 24 chip devices only.
The RIMM slots must be fully installed with
RIMM modules
t
o avoid breaking the signal lines.
To assure the electrical integrity of the Rambus
interface when installing only one RIMM module,
a C-RIMM is therefore necessary to complete the
signal lines.
User’s Manual
Содержание SI7
