Abit KG7, Руководство пользователя

Страница: 32 / 104

Chapter 3
KG7-Lite/KG7/KG7-RAID
3-4
Note
The display of this item might be different when you installed the different type of processors. We just
show you an example here.
User defined external clock and multiplier factor:
!
User Defined
&&&&
Warning
&&&&
The wrong settings of the multiplier and external clock in certain circumstances may cause CPU
damage
The wrong settings of the multiplier and external clock in certain circumstances may cause CPU
damage. Setting the working frequency higher than the specifications of PCI or of processor may
cause abnormal memory module functioning, system hangs, hard disk drive data loss, abnormal
functioning of the VGA card, or abnormal functioning with other add-on cards. Using
non-specification settings for your CPU is not the intention of this explanation, for which should be
used for engineering testing only, not for normal applications.
If you use non-specification settings for normal operation, your system may not be stable, and may
effect system reliability. Also, we do not guarantee the stability and compatibility for settings that are
not within specification, and any damage of any elements on the motherboard or peripherals, is not
our responsibility.
"
Multiplier Factor:
Three are several settings, shown as below:
!
x5
!
x5.5
!
x6
!
x6.5
!
x7
!
x7.5
!
x8
!
x8.5
!
x9
!
x9.5
!
x10
!
x10.5
!
x11
!
x11.5
!
x12
!
x13
!
Above x13
"
CPU FSB Clock (MHz):
You can increase the CPU FSB clock speed here. This means that you can independently increase
the CPU FSB clock speed. The DEC (decimal) numbers from 100 to 200 are available, with the
default setting at
100 . You can change this setting to increase CPU FSB clock speed. CPU FSB
speed above the standard bus speed is supported, but not guaranteed due to the CPUspecs.
"
FSB Rate (CPU:SDRAM:PCI):
Two options are available: 3:3:1
)
4:4:1.The default setting is 3:3:1 . You can change the ratio
between CPU, SDRAM and PCI bus.
"
Speed Error Hold:
Two options are available: Disabled
)
Enabled. The default setting is Disabled . If you change the
setting to “Enabled” when the CPU speed setting is wrong, the system will hold.
Normally, we do not recommend that you use the “
User Define
” option to setup CPU speed and PCI
clock. This option is for setup of future CPUs whose specifications are still unknown. The specifications
of all present CPUs are included in the default settings. Unless you are very familiar with all CPU
parameters, it is very easy to make mistakes when you define the external clock and the multiplier factor
by yourself.