Abisal Nils Extreme MTW03, Руководство пользователя

Страница: 6 / 21

STEP 1 Wear your helmet in the proper position
Always wear your helmet low enough in the front to protect the forehead (fig 1).
WARNING!
All fitting adjustments must be made with the
Helmut In the proper position. Failure to do so will
result in a poor fit, and may allow the helmet to
move out of position or come off in an accident.
STEP 2 Adjusting the straps
The front and rear side straps should join at a point slightly below and in front
of the ears (fig 2).
Always wear your helmet with the chin straps buckle fastened, and the strap
pulled tight. Make sure the strap is well back against the throat. Figures 3 and
4 show how to fasten and release the buckle. Make sure the loose ends of the
chin strap pass through the rubber O-ring, as shown in figure 5. If they do not,
they may loosen, and the helmet may come off in an accident.
STEP 3 Getting the correct fit
Adjustment are made too by using interior pads and by adjusting retention system (head lock). Follow steps 1-2,
above and then tighten or loosen head lock knob.
To tighten retention system turn the adjusting dial clockwise (fig 6). To Loosen retention system turn the adjusting
dial counterclockwise (fig 7).
When the helmet is in place, you should also feel a light pressure on the sides and top of your head. If you do not,
insert the thicker pads provided along the sides and top of the helmet to achieve a snug, comfortable fit.
WARNING!
If you cannot adjust the helmet to fit properly according to step 3, DO NOT USE THE HELMET. Replace it with a
different size or model.