64
ERROR MESSAGE & TROUBLESHOOTING
Error message & Troubleshooting:
E1:
It indicates no signal picked up for 8 seconds and the monitor stops.
Solutions:
Please check all the wires if they are well connected or any connecting pins bent.
Please consult dealer.
Please proceed self-testing (remove POWER KEY, press and hold SPEED UP &
START / STOP at the same time, then place POWER KEY back on while holding the
two buttons. Press START/STOP to confirm all the values until the monitor shows
"cal" and automatically enter self-testing).
E2:
It indicates the problems of EEPROM IC chip. Either the ID code is incorrect or
the data accessed from the IC chip is wrong.
Solutions:
Please change the monitor (consult dealer).
E3:
It indicates that the incline signal can't be read.
Solutions:
1.
Please proceed self-testing (remove POWER KEY, press and hold ENTER &
SPEED UP at the same time,
then place POWER KEY back on while holding the
two buttons).
Check all the wires if they are broken, damaged, or connecting pins bent.
Check if the fuse on incline controller was broken.
Change monitor or MCB, then test the machine.(consult dealer)
E4:
It indicates the incline signal is reversed.
Solutions:
Please consult dealer.
E5:
It indicates during body fat test, there's no pulse signal input.
Solutions:
Re-enter the body fat program to input setting values, and make sure both hands grip
on the sensor properly.
Содержание 513 120
