Abicor Binzel ROBO Compact W600, Руководство по эксплуатации

Страница: 40 / 156

EN - 14 BAL.0374.0 • 2019-04-01
6 Putting into operation ROBO Compact W600
6.3 Connecting the coolant

6.1.1 Euro-ZA on page EN-12

6.1.2 RPC on page EN-12
1 Connect the coolant supply hose (5) and the coolant return hose (6) to the coolant
recirculator.
WARNING
Risk of burns
The cable assembly overheats if the coolant level is too low.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Check the minimum fill level on the cooling unit.
• Ensure that the coolant supply and return hoses have been correctly installed. Coolant
supply = blue, coolant return = red.
• Do not use deionized or demineralized water as coolant or for leak and flow tests. This
may shorten your welding torch’s service life.
• For liquid-cooled welding torches, we recommend using ABICOR BINZEL BTC coolant.

Please consult the applicable safety data sheet.
• The cooling system must be purged of any air each time the device is commissioned and
after every cable assembly change: disconnect the coolant return hose from the coolant
recirculator and hold it over a collection receptacle. Close the opening on the coolant
return hose. Then re-open it by abruptly releasing it. Repeat until the coolant flows into the
collection receptacle continuously and without air bubbles.