EN - 8
5 Handle operating elements
MAG Welding torches
4.5 Feed in wire
1
Insert the wire in the wire feed unit as specified by the manufacturer.
2
Press the "Wire Jog" push-button at the wire feed unit until the wire comes
out of the contact tip.
5 Handle operating elements
Using a standard welding torch, the two-position mode of the trigger can be
activated.
5.1 Trigger with two-position function
1
Press the trigger on the handle and keep it pressed = welding is started.
2
Release the trigger = welding is stopped.
6 Operation
1
Open the shielding gas cylinder.
2
Switch on the power supply.
3
Setting the welding parameters.
4
Welding is started.
NOTE
• Each time the wire is changed, make sure that the cutting point is free
of burrs.
NOTE
• As the MAG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as power supply,
must be observed during operation.
NOTE
• Hose assemblies containing PVC hoses will start leaking if the return
coolant temperature is exceeded. Make sure not to exceed a return
coolant temperature of 60°C.
