Abicor Binzel PP Plus 36D, Руководство по эксплуатации

Страница: 26 / 76

EN - 8 BAL.0140 • 2018-10-15
4 Putting into operation PP Plus 36D/240D/401D
4.3 Mounting the wire guide
4.3.1 Liner
To be used for steel wires.
1 Lay down the cable assembly (9) straight and unscrew nut (6) from central connector (4) .
2 Slide the liner (8) through the wire conduit (3) until a noticeable resistance is felt in the inlet
nipple (2) .
3 Determine excess length x and pull out the liner (8) again.
4 Shorten the liner (8) by the dimension x.
5 Debur the cutting point and sharpen the spiral beginning to an angle of 40°.
6 Insert the liner cut to length (8) into the wire conduit (3) .
NOTICE
• Only use gas-tight, plastic-insulated wire guides to ensure a secure shielding gas cover
and a defined current contact.
• Bare liners give rise to a loss of shielding gas.
NOTICE
• New and unused liners must be abridged to the actual length of the cable assembly.
• To install the wire guide with a little preload, excess length is required.

Fig. 3 Liner on page EN-8
1 Torch neck
2 Inlet nipple
3 Wire conduit
4 Central connector
5 Multiple wrench
6 Nut
7 Holding nipple
8 Liner
9 Cable assembly
Fig. 3 Liner
40°
x
4 – 5 mm
1 2 3 4 5
6 7 8 9