EN - 6
4 Putting into operation
MB/RAB
4.1 Equipping the torch
Equip the torch neck according to the following figure:
4.2 Installing the spiral wire liner
4.2.1 Spiral wire liner
To be used for steel wires.
1
Lay down the hose assembly straight and unscrew gas nozzle and contact
tip from torch neck.
2
Unscrew liner retention nut from central plug and slide wire liner through the
cable hose up to the liner collet.
3
Screw down liner retention nut by hand and cut off the excess length of the
spiral wire liner flush with the torch neck or the tip adaptor.
4
Unscrew liner retention nut and pull out spiral wire liner.
5
Sharpen the spiral wire liner at the front to an angle of approx. 40° and
debur the edge.
CAUTION
Risk of injury
Piercing or puncture caused by electrode tip.
• Do not reach into the danger zone and wear protective gloves.
1
Type 15
2
Gas diffuser
3
Contact tip
4
Tip adaptor
5
Gas diffuser
6
Torch neck
7
Type 401/501
8
Type 401D/501D
9
Type 24/26/36/602/240D
10
Gas nozzle
11
Type 25
Fig. 1
Equipping the torch
1
10
2
7
3
4
6
11
5
9
8
