Abicor Binzel FEC W3, Инструкция по эксплуатации

Страница: 52 / 132

EN - 20
BAL.0675.0 • 2019-09-16
9 Maintenance and cleaning FEC W3
Check the following:
Service life of carbon brushes
The carbon brushes have a service life of approx. 800 hours. The service life is reduced by 30% each time a carbon brush
is replaced. The carbon brushes can be replaced twice in total. After two replacements, the motor must then be replaced.
9.2 Filter dedusting
Daily Monthly Yearly
• Visual inspection of extraction
system:
Fume extraction system or parts of
system damaged?
• Visual inspection of filter:
Filter not tight or dirty?
(trails of dust or deposits on the air
outlets)

9.4 Changing the filter on
page EN-23
• Visual inspection of the turbine
area:
Dust in the turbine area?
Remove the dust as required with
a suitable industrial vacuum
cleaner from dust class H13 and/
or a damp paper towel.
• Visual inspection of the cable
connections:
Cable connections damaged?
• Visual inspection of the exhaust air
filter:
Exhaust air filter not tight or dirty?

9.4.3 Replacing the exhaust air
filter on page EN-25
• Visual inspection of the W3 filter
cartridge
• Filling level of the dust collecting
drawer:
Dust collecting drawer full?

9.3 Emptying the filter housing on
page EN-22
• Visual inspection of the FEC filter
pad:
Filter not tight or dirty?

9.4.4 Replacing the FEC filter pad
on page EN-26
• Inspection of container for
tightness
• Visual inspection for tightness:
Are the seals damaged?
• Deterioration of the carbon brushes

Service life of carbon brushes on
page EN-20
Tab. 9 Maintenance intervals
CAUTION
• Suitable safety measures must be taken before performing maintenance and cleaning work.
• Maintenance and cleaning work must only be carried out on the extraction system in areas with locally filtered forced
ventilation.
• Check and wear your personal protective equipment.
• Personal protective equipment consists of protective clothing, safety goggles, a class P3 respiratory mask, protective
gloves and safety shoes.
• Nobody without personal protective equipment may stay near the dust collecting drawer when it is being filled with
the separated dust.
• The filter should be cleaned at least once per work shift, depending on how often the system is used.
• The filter must be cleaned immediately if the "Dirty" LED is illuminated on the control panel.
NOTICE
• This procedure must be carried out when the system is not in operation.
• Use only dry and oil-free compressed air (max. 5 bar - max. 6.5 bar).