Abicor Binzel AUTC 61GD, Руководство по эксплуатации

Страница: 30 / 68

EN - 14
9 Maintenance and cleaning MAG
9 Maintenance and cleaning
9.1 Cable assembly

See Fig. 2 Liner on page EN-9
1 Unscrew the cable assembly (3) on the machine side and bring it into a
stretched position.
2 Unscrew nut (6) and pull out liner (8) and replace it, if necessary.
3 Remove worn parts (1) , (11) , (9) , (10) from the torch neck (2) .
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the gas supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are recommended values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
• Remove any adhering welding spatter.
• Ensure that all threaded fittings are tight.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide liner with compressed air, wear suitable
protective clothing, in particular safety goggles.