Abicor Binzel ABIROB A 350GC, Руководство по эксплуатации

Страница: 18 / 40

Alignment jig 7 Maintenance and cleaning
EN - 9
6.2 Adjusting the Bending Angle
1 Plug on/screw in the adjusting sleeve (3) onto the gas nozzle receptacle.
2 Put the adjusting lever (4) onto the adjusting sleeve (3) and correct the bending angle slightly.
Check the concentricity of test mandrel (1) and measuring sleeve (2) constantly during this procedure.
The bending angle is correct if the test mandrel (1) fits easily into the bore of the measuring sleeve (2) .
7 Maintenance and cleaning
Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
7.1 Monthly cleaning
A monthly basic cleaning is recommended, and necessary in case of extreme working conditions.
CAUTION
Material damage
The torch neck can be damaged in case of too frequent and excessive bending.
• Perform only minor corrections.
1 Test mandrel
2 Measuring sleeve
3 Adjusting sleeve
4 Adjusting lever
Fig. 5 Adjusting
2
4
1 3