![Abicor Binzel ABICAR 1200 PRO Скачать руководство пользователя страница 55](http://html1.mh-extra.com/html/abicor-binzel/abicar-1200-pro/abicar-1200-pro_operating-instruction_3419892055.webp)
ABICAR 1200 PRO
10 Faults and troubleshooting
EN
-
25
► If you have any questions or problems, consult an appropriate specialist dealer.
10 Faults and troubleshooting
► Consult the documentation for the welding components.
► If you have any questions or problems, consult an appropriate specialist dealer.
As needed
Replace any loosely attached
or defective components.
► Have speed controllers and travel direction and weld start signal
switches replaced by professionals.
► Have any damaged cables replaced by professionals.
Tab. 7
Maintenance and cleaning intervals
Interval
Required actions
Description
Tab. 8
Faults and troubleshooting
Fault
Cause
Troubleshooting
Device cannot be switched on.
The mains supply light is off.
Device has no power.
► Inspect the power cable and, if
necessary, plug it in correctly.
Leads/drive belt have become loose or
motor is blocked.
► Consult your specialist dealer or the
manufacturer.
Guide rollers do not rotate.
The guide roller is defective.
► Replace guide rollers.
Guide rollers dirty.
► Clean guide rollers.
Wheel rotates eccentrically.
The wheel is not correctly fastened.
► Properly retighten screw for wheel
attachment.
The wheel is dirty.
► Clean or replace wheel.
The limit switch is not responding.
The limit switch is defective.
► Consult your specialist dealer or the
manufacturer.
The screen is black after switching
on.
The power cable, power switch, power
device or control device is defective.
► Consult your specialist dealer or the
manufacturer.
There is an error on the display.
Values cannot be read.
The display or the power device is
damaged.
► Consult your specialist dealer or the
manufacturer.
The following messages are shown
on the display:
The limit switch was triggered.
There is an obstacle in front of the device.
► Set the travel direction switch to the “O”
position.
► Remove obstacles.
The following messages are shown
on the display:
The limit switch was triggered.
There is an obstacle in front of the device.
► Set the travel direction switch to the “O”
position.
► Remove obstacles.
The following message is shown on
the display:
Switching between travel directions was too
fast.
► Set the travel direction switch to the “O”
position.
The following message is shown on
the display:
When switching on, the travel direction
switch is not set to “O”.
If the message is displayed during
operation, then the device is damaged.
► Set the travel direction switch to the “O”
position.
► Consult your specialist dealer or the
manufacturer.
Содержание ABICAR 1200 PRO
Страница 62: ...EN 32 Notes ABICAR 1200 PRO Notes...
Страница 63: ...ABICAR 1200 PRO Notes EN 33 Notes...