15)
Bolt the tongue assembly to the frame. Tighten to
50-71 ft-Ibs (68-96nm). Ensure the open side of the ball
coupler is facing up.
Be sure the wires DO NOT BECOME
PINCHED between the frame and the tongue.
Use bolts
from package labeled H.
16)
Place tongue
wires in hook on
coupler.
14)
On the tongue assembly, connect the male electrical
connectors to the female electrical connectors, ensuring
that the colors of the wires match. Use electrical tape as
shown below. Push excess wiring back into the frame.
BE CAREFUL NOT TO DAMAGE WIRES.
14
15
h
To secure the trailer wiring, wrap the
connections with black electrical tape
and use ZIP-TIES in a loop to prevent
the wires from unplugging.
9
877.788.7253 • ABIsupport.com
ABI® Workman Trailer Manual
13
13)
Mount each wheel/tire assembly to the hubs with 4
tapered lug nuts each. The taper of the lug nuts must face
toward the wheel. Install with the valve stem, on the tire,
facing away from the frame. Tighten the nuts gradually,
alternating between nuts opposite each other, to assure
even seating of the wheel onto the axle.
Inflate tire to recommended pressure on sidewall of tire.
16
