DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.
INSTALLATION GUIDE
This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with AS/NZS 3500.
structure in wall
max 450mm C’s
2
Fit waste and trap to basin.
1
Check the desired height of basin from floor.
3
4
Hold basin against wall aligning outlet of
trap with waste pipe. Extend telescopic trap
up or down to find desired height & cut waste
to suit trap.
If correct height and position is suitable, level
the top of the basin & mark out desired position.
Drill holes through the back of basin into structure within
Fix basin into structural support in wall.
5
Secure plumbing to basin and wall outlet.
Test by running water through the waste.
Place the cover plate over drain.
wall with a wood drill bit at maximum 450mm centres.
IN THE
BO
X
Silicon top and sides of
basin if necessary.
2 x Wall Plug
2 x Hanger bolt
2 x Plastic washer
2 x Metal washer
2 x Nut
1 x Basin
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INSTALLATION GUIDE
Level
