Optional accessories mounting
CABLE TYPES AND MINIMUM THICKNESS
4
Place the front cover [4] on both the columns and secure it with the 2 screws [7] near the ground. Attach the chain to the eyebolts that
protrude from the front covers and tighten it so that the chain at the centre of the passage is at a height X with respect to ground. Before
moving on placing the rear cover, make the electrical connections, as written in the following paragraph.
Refer to the attached CONT-R15 control unit manual.
POLY-PLUS
Upper module with neutral plate for housing of accessories and control panel
POLY-RING
Safety ring for metallic chain
POLY PLUS
1. Upper module
2. Base
3. Column
Put the base [2] Poly Plus inside the column [3]. Align the
4 holes [B] on the base with the 4 holes [B] on the
column.
Fix the base to the column with the 4 M10 x 20 screws
and the given nuts. Tighten the screws firmly!
The upper module [1] has 2 M10 threaded holes [A] at its
bottom. Lean the module on the base. Be sure to align
the holes and then fix it with the 2 given M10X20 screws.
POLY RING
Assemble the ring as you see
in the picture and fix it to the
eyelet and to the last link of
the chain.
the six-monthly periodic maintenance plan provides for:
- remove 230V power supply or batteries if present
- clean and grease the monorail guide and inner chain sprockets
- grease the tow chain
- check that the screws holding the column are well tightened
- check the electrical connections
- restore power supply
- check obstacle detection operation (encoder system)
- check the correct functioning of all the command and safety functions
- replace any worn parts
MAINTENANCE
